HP LaserJet Enterprise MFP M630 Series — Load Tray 2 and the 500-sheet trays

Go back

Clear jams
  • Clear jams in the document feeder
  • Clear jams in Tray 1
  • Clear jams in Tray 2, 3, or 4
  • Clear jams in the 1,500-sheet high-capacity input tray (Tray 5)
  • Clear jams in the right door
  • Clear jams in the lower-right door
  • Clear jams in the duplexer and fuser
  • Clear jams under the top cover and in the registration area
  • Clear jams in the output bin
  • Clear jams in the stapling mailbox accessory
  • Clear staple jams in the stapling mailbox accessory
Control panel walkaround
  • HP LaserJet M630 control panel functions
Customer self-repair (CSR) parts and supplies
  • Toner cartridges
  • Staple cartridge
Guides
  • Control Panel Guide
  • User Guide
Load the paper trays
  • Load Tray 1
  • Load Tray 2 and the 500-sheet trays
  • Load the 1500-sheet high-capacity input tray
Maintenance and jam clearing
  • Clean the scanner and white backing
  • Clean the backside scanner
  • Clean the document feeder pickup rollers and separation pad
Product views
  • Product front view
  • Product back view
  • Interface ports
Quick Sets
  • Use a Quick Set
Save to SharePoint® (M630z)
  • Use Save to SharePoint®
Standard scan/send features
  • Send a scanned document to one or more email addresses
  • Send a scanned document to a network folder
NOTE:

The procedure to load paper for the 500-sheet trays is the same as for Tray 2. Only Tray 2 is shown here.

  1. Open the tray.

    NOTE:

    Do not open this tray while it is in use.

  2. Adjust the paper-length and paper-width guides by squeezing the adjustment latches and sliding the guides to the size of the paper being used.

  3. Load paper into the tray. Check the paper to verify the guides lightly touch the stack, but do not bend it. For information about how to orient the paper, see the product User Guide or support site.

    NOTE:

    To prevent jams, do not overfill the tray. Be sure that the top of the stack is below the tray full indicator.

    NOTE:

    If the tray is not adjusted correctly, an error message might appear during printing or the paper might jam.

  4. Close the tray.

  5. The tray configuration message displays on the product control panel.

  6. Touch the OK button to accept the detected type and size, or touch the Modify button to choose a different paper size or type.

    For custom-size paper, specify the X and Y dimensions for the paper when the prompt displays on the product control panel.

  7. Select the correct type and size, then touch the OK button.