HP LaserJet Enterprise M604, M605, M606 — Load Tray 2 and the 500-sheet trays

Go back

Clear paper jams
  • Clear paper jams in Tray 1
  • Clear paper jams in Tray 2 and the 500-sheet trays
  • Clear paper jams in the optional 1,500-sheet high-capacity tray
  • Clear paper jams in the toner-cartridge area
  • Clear paper jams in the rear output bin
  • Clear paper jams in the fuser area
  • Clear paper jams in the output bin
  • Clear paper jams in the duplexer
  • Clear paper jams in the envelope feeder
  • Clear paper jams in the 5-bin mailbox
  • Clear paper jams in the stacker or stapler/stacker
  • Clear staple jams in the stapler/stacker
Control panel walkaround
  • Control-panel view (4-line control panel, n and dn models only)
  • Control-panel view (touchscreen control panel, x models only)
Customer self-repair (CSR) A parts and assemblies
  • Toner Cartridge
Load trays
  • Load Tray 1
  • Load Tray 2 and the 500-sheet trays
  • Load the optional 1,500-sheet high-capacity tray
  • Load the optional custom media tray
  • Load envelopes
Product views
  • Product front view
  • Product back view

The following information describes how to load paper in Tray 2 and the optional 500-sheet trays (part number F2G68A). This trays hold up to 500 sheets of 75 g/m2 (20 lb) paper.

NOTE:

The procedure to load paper for the 500-sheet trays is the same as for Tray 2. Only Tray 2 is shown here.

  1. Open the tray.

    NOTE:

    Do not open this tray while it is in use.

    Open the tray

  2. Before loading paper, adjust the paper-width guides by squeezing the adjustment latches and sliding the guides to the size of the paper being used.

    Adjust the guides

  3. Adjust the paper-length guide by squeezing the adjustment latch and sliding the guide to the size of the paper being used.

    Adjust the guides

  4. Load paper into the tray. Check the paper to verify the guides lightly touch the stack, but do not bend it.

    NOTE:

    To prevent jams, adjust the paper guides to the correct size and do not overfill the tray. Be sure that the top of the stack is below the tray full indicator.

    Load paper

  5. Close the tray.

    Close the tray

  6. The tray configuration message displays on the product control panel.

  7. If the paper size and type shown is not correct, select Modify to choose a different paper size or type.

    For custom-size paper, specify the X and Y dimensions for the paper when the prompt displays on the product control panel.

    X and Y dimensions