HP LaserJet Enterprise M806 — Tray 2

Go back

Control panel walkaround
  • HP LaserJet M806 control panel
Easy-access USB printing
  • Use easy-access USB printing
  • Use the staple/collate feature (optional finishing accessory)
Load the paper trays
  • Tray 1
  • Tray 2
Maintenance and jam clearing
  • Clear jams in Tray 1
  • Clear jams in Tray 2 and Tray 3
  • Clear jams in Tray 4 and Tray 5
Print
  • Select staple and hole-punch locations
Product views
  • Front view
  • Back view
  • Formatter view
  • Control-panel view
  • Stapler/Stacker (with or without hole punch)
  • Booklet maker
  • Supplies walkaround
Supplies
  • Toner Cartridge
  • Staple cartridge refill
  • 2000-Staple Cartridge Kit (2-pack) for Booklet Maker

The procedure to load paper for Tray 3 is the same as for Tray 2. Only Tray 2 is shown here.

NOTE: To avoid jams, do not open the drawers during printing, and do not load paper above the fill lines on the paper guides.

  1. Open the tray.
  2. Adjust the paper-length and paper-width guides by squeezing the adjustment latches and sliding the guides to the size of the paper being used.
  3. Load paper into the tray. Check the paper to verify the guides lightly touch the stack, but do not bend it.
  4. Adjust the side guides so that they lightly touch the paper stack, but do not bend it.

    NOTE: To avoid jams, do not load paper above the fill lines on the paper guides.


    An error message might appear during printing or the paper might jam if the tray is not adjusted correctly.